Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
13 Cards in this Set
- Front
- Back
- 3rd side (hint)
Doors |
Door panel in good condition
Dot lettering is a minimum of 2 in height 1/2 in width, in good condition
Doors open/close easily
Locks work properly
No missing hinges/latches
Rubber seal is not missing and in good condition. |
6 |
|
Windows |
Rolls up/down easily
Windows are not cracked, broken, missing
Rubber seal not missing and in good condition |
3 |
|
Mirror/mirror bracket |
Mirror bracket is securely mounted to the door. Mirrors are securely mounted to the mirror brackets
2 types of mirrors: flat, convex
Mirrors are clean, not cracked or missing
Well adjusted Not vibrating at idle (600-900 rpm.
|
6 |
|
Handrail |
Securely mounted to cab Not cracked or bent no missing bolt |
2 |
|
Catwalk |
Also called deck plate
Securely mounted free of grease, oil, ice |
3 |
|
Frame |
The frame is the foundation of the vehicle
Not cracked, bent or welded.
The frame is 2 solid steel rails bolted together with cross members |
3 |
|
Windshield |
Windshield is clean and not cracked
Rubber seal is not missing and in good condition.
Safety inspection sticker on driver side (expires every 6 months)
Registration and insurance on passenger side of windshield ( expires every year)
|
4 |
|
Wiper blades |
Soft and flexible
Wiper ares are not bent and works properly. |
2 |
|
Fuel tank |
No cracks, holes, or leaks
Not hanging to low
Securely mounted to frame with 2 metal straps and 2 rubber pads
Steps securely mounted and free of grease, oil, ice
Fuel caps are tight and open and close properly
Cap has a safety chain and the rubber seal is not missing and in good condition
Fuel crossover lines are not hanging to low or near exhaust
Gauge wire is properly mounted and working |
8 |
|
Steering wheel |
Steering wheel is round not bent Properly mounted with a nut Has an electronic horn No more then 2in or 10 degrees of free play on a 20 in steering wheel |
4 |
|
Steering system |
Steering column is smooth, not bent U-joint is tight, properly greased Steering wheel shaft is smooth, not bent, not cracked U-joint is tight, properly greased Steering gear box is securely mounted to the frame, not cracked, not leaking, no missing bolts Power steering fluid reservoir is not leaking, at proper level Pitman arm is not cracked or bent, securely mounted to the steering gear box and drag link Drag link is not cracked or bent, no welds, one end of the drag link is mounted to the pitman arm with a castle nut and cotter pin, other end of the drag link is mounted to the steering ring knuckle with a castle nut and cotter pin Steering ring knuckle is not bent or cracked and is mounted to the spindle Spindle is not bent and properly greased Steering arm is not bent or cracked and is mounted to the tie rod with castle nut and cotter pin Tie rod is not cracked or bent no welds |
12 |
|
Suspension |
Holds vehicles weight and it's load Keeps axles in place |
2 |
|
Front suspension |
Frame is solid not bent, cracked, no welds Front and rear spring hangers are securely mounted to the frame, not cracked, no missing bolts Steel or rubber bushing and eyeball are not missing, good condition Leaf spring are not missing, not cracked,broken or shifted C-clamps are not missing, well tightened, good condition Spring shackle is properly greased, rubber bushing and eyeball not missing, good condition Saddle, axle seat, and axle not cracked, not bent U-boat are not missing, well tighten, good condition Nuts are tight, not missing Hydraulic shock absorber are securely mounted to the frame and axle, not leaking, not missing |
10 |