Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
30 Cards in this Set
- Front
- Back
The actual mechanical advantage of a belt drive-system equals:
|
The Ratio of Torques
|
|
A decrease in angular speed on the output pulley of a belt drive system causes the amount of torque on the output pulley to:
|
Increase
|
|
What increases from input to output in a hydraulic jack?
|
Force and Piston Area
|
|
What decreases from input to output in a hydraulic jack?
|
Piston Movement
|
|
At a power substation, electrical transformers are used to:
|
Step-up Voltage
|
|
How does the linear impulse of a 10 pound force acting on an object for 5 seconds compare to the linear impulse of a 5 pound force acting on the same object for 10 seconds?
|
The Same as
|
|
A hand cranked generator produces 45 watt of output power. The handle is 6in long and it requires 12.5 pound of force to turn the generator at 1 rev per second. What is the effciency of the generator?
|
84.5%
|
|
A waterwheel uses fluid energy to rotate a shaft. What's the fluid power input to the waterwheel when the shaft output is 15,000 hp and the energy conversion is 37% efficient?
|
5,550 hp
|
|
A single junction thermocouple is made of:
|
Two wires of different metals
|
|
With a constant voltage applied to the strain gages attached to a bridge superstructure, as the bridge is stressed resistance in the strain gages change. An appropriate instrument to monitor the stress would be a/an:
|
Amp Meter
|
|
Because of its accuracy and its ability to measure both direct pressure and indirect pressure, fluid pressure sensors are often calibrated against a
|
Manometer
|
|
A fluid transducer that measures altitude is called a:
|
Altimeter
|
|
A loading ramp rises 12 feet on one end to a platform. If the ramp has an IMA of 4, how long is the ramp?
|
48 feet
|
|
The ideal mechanical advantage of a rotational force transformer is always:
|
Equal to or greater than the actual mechanical advantage
|
|
If the efficiency of a gear drive is 80% and the IMA is 20, what would be the actual mechanical advantage?
|
16.0
|
|
What is the mechanical advantage in a hydraulic jack whose input force of 20 pound delivers a 300 pound output force to the load?
|
15
|
|
The ideal mechanical advantage of a jack is given as:
|
IMA = Di/Do
|
|
Current flow from the secondary windings of an electric transformer can be monitored by connecting a:
|
Digital multi-meter in series
|
|
in an electrical transformer designed to step down voltage, if resistance is present in the coil windings the actual electrical advantage can be found by:
|
Dividing the current in by the current out
|
|
What ratio, because of it's consistency, is used to determine ideal electrical advantage in electrical transformer?
|
Wire Turn
|
|
In the English system of units a slug is a unit of:
|
Mass
|
|
Angular impulse is found with the equation:
|
AngImp = T X W
|
|
A rotating object's moment of inertia times its angular velocity is known as:
|
Angular Momentum
|
|
A mechanical energy convertor changes:
|
Mechanical Energy to thermal, electrical, or fluid energy
|
|
In the English system, a common unit for fluid energy is:
|
FtLB
|
|
A 0.5 hp electric motor delivers 373 watts of output mechanical power. The motor is 93.2% efficient. The amount of input power needed to run the motor is:
|
400 watt
|
|
The purpose of a thermopile is to convert
|
Heat energy to electrical energy
|
|
An an accelerometer, a piezoelectric crystal generates an electric output when the:
|
Rate of motion of a certain mass attched to the crystal is changed
|
|
Mechanical transducers detect mechanical change such as a movement and:
|
Change the information into useful signals that can be interpreted and used
|
|
A device used to "sense" the condition of a fluid system is called a:
|
Fluid Transducer
|