Endothermic Reaction Lab

Improved Essays
Following Added by Brandon Boocks:
During a chemical reaction, one or more chemicals are turned into one or more other chemicals. For example iron and oxygen both combine to rust or just simply things that are burning or exploding are examples of chemical reactions. Endothermic describes the type of chemical reaction in which energy is absorbed. Energy needed in the form of heat is needed for an endothermic reaction to be possible. Heat is put into the reaction or, as stated before, it is absorbed. The textbook, Conceptual Integrated Science, gives photosynthesis as an example of an endothermic reaction. The chemical reactions that occur during photosynthesis have an overall net absorption of energy. Another example of an endothermic chemical

Related Documents

  • Great Essays

    In the Acid-Catalyzed Hydration of norbornene, water and sulfuric acid were added to the C=C double bond to form norborneol. Sulfuric acid acted as a catalyst, where it was not consumed in the reaction and helped to propel the reaction forward, as it was vital in forming hydronium ion and breaking the double bond. Both the products endo-norborneol and exo-norborneol were synthesized; however regioselectivity and stereoselectivity played a role as to which product was more preferred and whether the equatorial or axial orientation of the hydroxy group was favored. The setup of the Cold-Finger, and the ability of norborneol to sublime readily allowed for the purification of the crude product to obtain the diastereomeric products exo- and endo-norborneol.…

    • 1629 Words
    • 7 Pages
    Great Essays
  • Decent Essays

    Limiting Reactant Lab

    • 177 Words
    • 1 Pages

    The objective of this lab was to identify the limiting reactant, which the lab's data showed the limiting reactant to be Beaker A. According to the Limiting Reactant Document, it states "limiting reactants control the amount of product possible for a process because once the limiting reactant has been consumed, no further reaction can occur"(2nd paragraph). The mole of Beaker A was .00500 of CuCl2 as Beaker B's was .0056 mol of CuCl2. During the lab, Beaker A's solution had a larger amount of aluminum foil pieces than Beaker B's solution; showing that the limiting reaction has to have a smaller volume. In the Limiting Reactant Document, based on their second experiment, " Substance A and B react in a 1:1 ration, and with only 0.5 mol of Substance…

    • 177 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    Alka Seltzer Reaction Lab

    • 545 Words
    • 3 Pages

    Observations: This experiment was divided into two parts: one part was to observe the properties of a single Alka Seltzer tablet and the second part was to find the percentage of CO2. In the first part of the experiment, the visible properties of Alka Seltzer were observed and recorded. Each Alka Seltzer contains the same three ingredients: 325 mg of Aspirin, 1000 mg of Citric Acid, and 1916 mg of Sodium Bicarbonate.…

    • 545 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    In order to safely dispose of a solution with a pH of 12, the solution needs to be diluted with an acid to neutralize the basic solution. The pH range should be between 5 to 8 to be ready for disposal. 2. A graduated cylinder, Erlenmeyer flask, and beaker were used to measure a 60-mL volume. Which of these devices seems to be the most accurate for measuring a 60-mL volume?…

    • 1978 Words
    • 8 Pages
    Improved Essays
  • Improved Essays

    Grignard Reaction Lab

    • 1332 Words
    • 6 Pages

    This lab was a two week long lab called the Grignard Reaction lab. The purpose of this lab was to perform the Grignard reaction and to obtain the final product triphenylmethanol from a halide, phenylmagnesium bromide and the starting material, methyl benzoate along with the Grignard reagent. Bromobenzene, magnesium turnings, and anhydrous ether were needed to form the Grignard reagent. To synthesize the reagent, react the reagent with methyl benzoate to form a tertiary alcohol. The objective of the Grignard Reaction lab was to obtain the actual yield of the product, to calculate theoretical and percent yield of the product, and to record the melting point of the product.…

    • 1332 Words
    • 6 Pages
    Improved Essays
  • Improved Essays

    1. a. My data demonstrated the law of conservation of mass in part 5 of the experiment, dissolving sugar in water. The law of conservation mass states that matter cannot be created or destroyed by can enter or leave the system. The system’s change in mass was 0.00 grams, resulting in support of this statement.…

    • 456 Words
    • 2 Pages
    Improved Essays
  • Decent Essays

    Ap Chemistry Lab Report

    • 140 Words
    • 1 Pages

    There may have been errors in the lab that may have affected the results of the lab. There may have been mistakes: a person may have not measured the substances correctly while retrieving the liquids in the graduated cylinder, or not have been watching the conductivity probe while the group was measuring the electrolyte solution. Along with these, there is also the issue of timing the testing incorrectly. Adding onto this, there may have been a slight spill where the accurate amount of the substance being used was not completely added into the water for testing.…

    • 140 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    Chemiluminescence is a process where light is produced by a chemical reaction. Instead of using an electrical source. An example of this would be if go outside during a fall night and see a firefly glowing during the night fall using its Chemiluminescence. There are chemicals inside one simple glowstick.…

    • 662 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Uncatalyzed Reaction Lab

    • 882 Words
    • 4 Pages

    Introduction In this experiment, we mixed different amounts of reactants and measured the volume of O2 they produced so that we could determine the rate and order of the reaction. Three trials were done, the first trial acted as a baseline, then the following two trials each varied the concentration of a single reactant, allowing us to calculate the order of the reaction. Additionally, the temperature of the solution was changed to see what effect that would have on the rate. Using this information the activation energy for this reaction could be calculated and compared to the activation energy of the uncatalyzed reaction.…

    • 882 Words
    • 4 Pages
    Improved Essays
  • Decent Essays

    Kinetic Reaction Lab

    • 527 Words
    • 3 Pages

    Purpose The purpose of this experiment is to identify the rate constant in kinetics reactions during the t-butyl chloride convert into hydrolyzed. Theory Kinetics reaction analyzes the how fast the chemical reaction occurs when two solution mix together.…

    • 527 Words
    • 3 Pages
    Decent Essays
  • Improved Essays

    Reaction Lab

    • 1809 Words
    • 8 Pages

    The experiment began with a reaction of a 1cm3 cube of lamb liver and 5mL of hydrogen peroxide solution being put in test tubes in a beaker filled with 10℃ water until the temperatures of the liver and hydrogen peroxide were 10℃ also. The liver was put into a 100mL measuring cylinder and the hydrogen peroxide was also poured in as the timer was started. After twenty seconds, several millilitres of froth had been produced from the chemical concoction. This froth was recorded into a results table, and the previous steps were repeated but with increasing temperature increments of 10℃ until 50℃. After carefully completing the experiment, the final results obtained by measuring the volume of the froth produced after 20 seconds, were recorded in a table - see Table 1, and able to be observed in a graph, see Figure 7.…

    • 1809 Words
    • 8 Pages
    Improved Essays
  • Decent Essays

    Limiting reactants occur in a reaction when one of the reactants runs out and there is excess of another reactant. It is important to understand limiting reactants because it allows us to adjust the amount of chemicals we need to create a product without having excess chemicals. On October 5, 2017, we completed a lab in which we determined which chemical was the limiting reactant in a reaction by adding each chemical to the excess chemical and observing which formed a precipitate. II. Data, Results, and Evidence…

    • 291 Words
    • 2 Pages
    Decent Essays
  • Decent Essays

    Luminol Reaction Lab

    • 217 Words
    • 1 Pages

    As known, the chemical reaction of luminol can be classified as a process of chemiluminescence. The luminol chemical reaction can be compared to the chemical reaction of a glow stick. If a chemical reaction is at a cold/cooler temperature, it occurs at a slower rate. If a chemical reaction is at a hotter/warmer temperature, it occurs at a faster rate. If it is cooler/cooler it last longer, because it slow down.…

    • 217 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    The Hot Ice Experiment

    • 265 Words
    • 2 Pages

    Enthalpy (ΔH) if negative indicates an exothermic reaction. ΔH = energy used in bond breaking reactions − energy released…

    • 265 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Enthalpy Lab Report

    • 840 Words
    • 4 Pages

    Almost all chemical reactions involve a loss or gain of heat. This change in heat is called enthalpy. The goal of this experiment is to calculate enthalpy for three different reactions. To calculate the enthalpy of a reaction, a calorimeter is used to measure the change in heat energy from mixing different substances. The change of temperature is found by comparing the change in temperature of the system to the temperature of the surroundings.…

    • 840 Words
    • 4 Pages
    Improved Essays