Clean Flame Test Wire

Decent Essays
Show More
A clean flame test wire was inserted into 0.2 M NaCl and also placed on the flame reputedly. A bright yellow persistent flame was a positive test of sodium being presented, then repeat the same instructions for the unknown ion. After the flame test wire was clean 0.2M KCl was dipped into the flame resulted a lavender color after several trials as well as the unknown solution. 10 drops of 0.1M Ca(NO3)2 in a test tube and 2-3 drops of 1M Na2C2O4, a white precipitate of calcium was present. The process was repeated for the unknown solution which had the same results. In another test tube 10 drops of 0.1M Ca(NO3)2 and 3 drops of 6M HCl was added and flame tested. A 1M NH3 of 10 drops 0.5M AlCl3 was added until the solution turned blue. 3M drops of HC2H3O2 d was added …show more content…
Ammonia, NH3 10 was added to a test tube and 10 drops of 0.5m CuSO4. The result was recorded as the rest of every trial in the experiment with the different chemicals. 10 drops of 1M Na2CO3 was added with 10 drops of 6M HCl. Bubbles were formed with no color in both solutions. The 10 drops of 5.0M Na2SO4 to a test tube was dropped and 10 drops of 1M HCl as the solutions were mixed white precipitate was resulted and record for the unknown solution also. 10 drops of 1.0M Na3SO4 was added to the test tube, 10 drops of 6M HNO3 was the added. 10 drops of 0.5M (NH4)2 MoO4 added and mixed. The test tube was then heated in boiling water bath for 5 minutes this was the remove from the bath and led to cold for 10 minutes. The solution in the test the was yellow. A 5 drops of 1M HNO3 , 10 drops of 0.2M NaCl was added into a test tube. 2-3 drops of 0.1M AgNO3. A white precipitate resulting the presence of chlorine was present. 10 drops of 0.5M KSCN was placed into a test tube and 10 drops of 3M HC2H3O2 this solution was mixed. Then 0.1M Fe(NO3) until it was red. After conducting all the experiment procedure the observations were

Related Documents

  • Decent Essays

    Unknown White Compound Experiment
    • 159 Words
    • 1 Pages

    Unknown White Compound Experiment

    Hazardous waste is dangerous to the environment and human health when not disposed properly, meaning cautions need to be taken seriously as chemistry students while working in lab. The objective of the Unknown White Compound experiment was to identify the compound by examining its chemical and physical properties. Identifying the unknown white compound to be potassium nitrate was achieved by completing the solubility test, flame test, pH paper test, ion test, pH probe test, conductivity probe test, and synthesizing silver nitrate and potassium chloride to form potassium nitrate. Uncertainty can be due to small contaminations from glassware not properly cleaned, molarity of chemicals not being exact, and not properly collecting the precipitate…

    • 159 Words
    • 1 Pages
    Decent Essays
    Read More
  • Improved Essays

    Nine Unknown Solutions Experiment
    • 791 Words
    • 4 Pages

    Nine Unknown Solutions Experiment

    From the 36 mixtures there were certain mixtures that formed a colored precipitate i.e. white, black, brown, cream, and cloudy reactions were occurring. The reagent that was able to form the most precipitate was AgNO3 making the process of determining the compounds easier. After all of the solutions were determined the test tubes were washed with distilled water three times and put in to the waste bucket and the lab area was cleaned up by putting back the plastic dropper back in to place and wiping the counter…

    • 791 Words
    • 4 Pages
    Improved Essays
    Read More
  • Improved Essays

    Set 1-Silver Nitrate Hydrochloric Acid
    • 495 Words
    • 2 Pages

    Set 1-Silver Nitrate Hydrochloric Acid

    In this experiment, identifying the acids, bases, or neutrality of the unknown substance in a specific set are used to find the actual substances. The following sets of substances could have been assigned: Set 1 - Silver nitrate (AgNO3), Manganese(II) nitrate (Mn(NO3)2), Barium nitrate (Ba(NO3)2), Hydrochloric acid (HCl), Sodium Hydroxide (NaOH); Set 3 - Silver nitrate (AgNO3), Barium nitrate (Ba(NO3)2), Hydrochloric acid (HCl), Sulfuric acid (H2SO4), Sodium Hydroxide (NaOH); Set 4 - Silver nitrate (AgNO3), Lead (II) nitrate (Pb(NO3)2), Hydrochloric acid (HCl), Ammonia (NH3), Water (H2O). From the substances above Hydrochloric acid (HCl) is the stronger acid, and Sulfuric acid (H2SO4) and Lead (II) nitrate (Pb(NO3)2 are the weaker acids. If the substance is not an acid nor a base, the substance is neutral. In each set there were three neutral compounds, one acid, and one…

    • 495 Words
    • 2 Pages
    Improved Essays
    Read More
  • Improved Essays

    Unidentified Compound Lab Report
    • 757 Words
    • 4 Pages

    Unidentified Compound Lab Report

    By placing the nichrome wire in our compounds and putting it into the flame we can analyze the color of the flame to determine which cation is present in our compound. Along with the flame test, came the ammonium test to detect if the cation, ammonium, is present. By adding 1mL of our compound solution and 1mL 6M NaOH, a smell will develop if the ammonium cation is…

    • 757 Words
    • 4 Pages
    Improved Essays
    Read More
  • Improved Essays

    Unknown Compounds
    • 695 Words
    • 3 Pages

    Unknown Compounds

    When hydrochloric acid was added to the unknown and known solutions, both resulted in no reaction. This also occurred when potassium hydroxide was added to both of the solutions. Barium chloride was then added to the two solutions, which resulted in a cloudy white precipitate from both of the solutions. A cloudy white precipitate also formed when calcium nitrate and ammonium nitrate were added to both the unknown and known solutions. These reactivity tests were conducted in order to establish how the unknown compound would react with acids, bases, and salts.…

    • 695 Words
    • 3 Pages
    Improved Essays
    Read More
  • Great Essays

    Discussion Lab Report Discussion
    • 931 Words
    • 4 Pages

    Discussion Lab Report Discussion

    Then we did an anion test and discovered the compound reacted with chloride by producing a white precipitate. The precipitate that formed was an insoluble solid because Cl of NaCl reacted with Ag of AgNO3, creating a Cl- ion above the aqueous solution [3], results on Table 2. Finally we used a cation flame test, results on Table 4. When we burned the unknown substance the flame was a bright orange, yellow color. This was because the flame reacted with the Cl of NaCl causing…

    • 931 Words
    • 4 Pages
    Great Essays
    Read More
  • Improved Essays

    Hydrate Lab
    • 805 Words
    • 4 Pages

    Hydrate Lab

    The substance was stirred until dissolved. The liquid solution produced a blue color as soon as the cupric sulfate dissolved. Prior to this 1.127 grams of Zinc was gathered along with Hydrochloric acid. Both the Zinc and Hydrochloric acid were poured in gradually creating a reaction. A stirring rod was used to stir this while the reaction occurred.…

    • 805 Words
    • 4 Pages
    Improved Essays
    Read More
  • Improved Essays

    Unknown Compounds
    • 816 Words
    • 4 Pages

    Unknown Compounds

    Given an unknown compound in container 3, solubility tests, cation tests, anion tests, and conductivity tests can be used to determine the various properties of the unknown to then make a positive identification of the unknown. These results will not only show chemical and physical properties but also what the unknown compound might react with to form other compounds. After performing the four anion tests, a positive identification was able to be made showing that the unknown compound contained a chloride ion since a white precipitate was formed from the reaction (Table 1). The sulfate, nitrate, and carbonate tests all yielded negative results when no precipitate was formed. The reaction of the chloride anion is as follows: Cl-…

    • 816 Words
    • 4 Pages
    Improved Essays
    Read More
  • Improved Essays

    Zinc Acetate Double Displacement Reaction
    • 95 Words
    • 1 Pages

    Zinc Acetate Double Displacement Reaction

    represents a double displacement reaction. When zinc acetate, a clear liquid, and sodium phosphate, also a clear liquid, were combined in a test tube, they formed two different liquids. The reaction between the zinc acetate and the sodium phosphate happened almost immediately when combined together. One of the liquids was clear while the other was a milky white color. The clear liquid was sodium acetate and the white liquid is zinc phosphate, according to the MSDS.…

    • 95 Words
    • 1 Pages
    Improved Essays
    Read More
  • Improved Essays

    Cation Flame Test
    • 586 Words
    • 3 Pages

    Cation Flame Test

    Using qualitative analysis, two cations in an unknown solution was identified. After repeated mixing, centrifugation, and decanting, lead was confirmed in Part A and barium in Part B. In Part C, different colored flames of metal species were observed using cation flame tests. Formula unit, total ionic, and net ionic equations were then composed for the identified cations. If the experiment were to be repeated, step 13 could be ommitted as barium was already confirmed in step 12 with the formation of yellow percipitate barium chromate, and calcium was not confirmed with step 14 when a white percipitate calcium oxalate was not present…

    • 586 Words
    • 3 Pages
    Improved Essays
    Read More
  • Decent Essays

    Comparison Of Chronobutene And 1-Chlorobutane
    • 105 Words
    • 1 Pages

    Comparison Of Chronobutene And 1-Chlorobutane

    To explain for these observations, the tubes using for the three chemical may contain other compounds from the previous experiment. Therefore, some tubes have precipitations due to the reactions between unknown substrates and the reagents - AgNO3 and NaI.…

    • 105 Words
    • 1 Pages
    Decent Essays
    Read More
  • Improved Essays

    Photosynthesis And Cellular Respiration Lab Report
    • 1180 Words
    • 5 Pages

    Photosynthesis And Cellular Respiration Lab Report

    Determining The Process of Photosynthesis And Cellular Respiration Using Elodea and Yeast Introduction Photosynthesis is an essential process to life on earth, in which plants and other organisms use sunlight to create food from oxygen, and carbon dioxide. Cellular respiration is when energy in food is released and converted to ATP, which is then used as chemical energy to complete tasks within a cell. This process usually requires oxygen and releases carbon dioxide. Photosynthesis and cellular respiration are similar in some areas and different in others. The purpose of both of the process is to produce energy, but they have different ways of achieving this goal.…

    • 1180 Words
    • 5 Pages
    Improved Essays
    Read More
  • Improved Essays

    Flame Test Lab Report Essay
    • 885 Words
    • 4 Pages

    Flame Test Lab Report Essay

    In this experiment, two cations in an unknown solution were found using qualitative analysis. For Part A, the solution was to contain either silver or lead, while in Part B, the solution that was set on the side form Part A was identified to contain either calcium or barium. Part C explored a different method through the use of cation flame tests to observe colored flames from six metal chloride solutions. In Part A, the initial step was to add HCl to the unknown sample.…

    • 885 Words
    • 4 Pages
    Improved Essays
    Read More
  • Great Essays

    Whole Grain Cereal Lab Report
    • 1251 Words
    • 6 Pages

    Whole Grain Cereal Lab Report

    b. Add two drops of 6.0M HCl(aq), 0.5mL 10% Hydroxylamine-HCl, six drops 2.0M Sodium Acetate, and 1.0mL 0.1% 2,2-Dipyridyl solution to the test tube. c. Fill the test tube to the 10mL mark with DI water and the color will fully develop in 15 minutes d. Prepare the four other standard solutions with appropriate amounts of the solutions. 9. The sample uses 2.0mL from the volumetric flask with the dissolved Fe and add the appropriate reagents. 10.…

    • 1251 Words
    • 6 Pages
    Great Essays
    Read More
  • Improved Essays

    Iodometry Lab Report
    • 1421 Words
    • 6 Pages

    Iodometry Lab Report

    The solution was cooled in ice bath and DI water is added, followed by the addition of NH3 drop wise. The purpose of this step is to create a slightly acidic to neutral solution, which is an ideal condition for the redox reaction as mentioned above. Addition of NH3 will form Cu(NH3)42+,a copper tetramine complex with a dark-blue color, indicating a slightly basic solution. Adding H2SO4 will bring the solution to a lighter blue color, indicating that it is slightly acidic to neutral. As discussed previously, this will prevent iodide from being oxidized by atmospheric oxygen in the presence of excess acid.…

    • 1421 Words
    • 6 Pages
    Improved Essays
    Read More

Related Topics

Ready To Get Started?
Discover
Company
Follow
©2024 Cram.com
Privacy Policy |  About Ads |  Site Map |  Advertise  | 
  • Cookie Settings